Ningbo Yiduan Precision Machinery Co.,Ltd
call us on: +86-574-59128928
Categories
Ningbo Yiduan Precision Machinery Co.,Ltd
Exhibition
Home > Exhibition > Content

Punching machinery used

Presses for punching, forming shall follow the following procedures. When two or more operations, should be driving, pay attention to good coordination. Work should die before falling on, disconnect the power, and make any necessary cleaning. Exposed outside of the compressor power-train components, you must install the protective cover, prohibition in the case of removing the protective cover or driving test. If necessary, open the empty test. Install the die must open the slider to bottom dead center, shut height must be correct, avoid eccentric loads; die must be fastened firmly and pressure checks.

Work should concentrate, no hands and tools and other objects into the hazardous area (see safety rules the 4th) found presses running unusual or abnormal noise, (such as batter, crackling) should stop feeding into it. If turned loose parts, control devices malfunction, (see Introduction) every finish-a workpiece, hands or feet must leave the button or pedal, in order to prevent misuse. Work, should check the protective devices are complete press and flywheel running smoothly; pedal device top and sides with no protection, reliability of operation and flexible; and remove objects hampered operations at the workplace.

Blanking force must be approved, non-overloaded operations. When installing, remove the mold, you must cut off the power supply. Die installation must be secure and reliable. Adjust by using manual or dynamic approach, step by step, prior to confirming a good tune to prohibit vehicle. Actions, be focused, do not talk while doing, to cooperate with each other to ensure safe operation. Against two or more persons simultaneously punch. If necessary, there must be a special command and was responsible for the foot device operation. Mold to any part of the body is prohibited in feed discharge range there should be specialized tools.


Contact Us
Add:Dalin Industry Zone, Huangbiao Town, Xiangshan, Ningbo
Contact Bill
Tel:86-574-59128928
Mob: 8613780097855
Fax:86-574-59128928
Email:bill@nbyiduan.com

Copyright © Ningbo Yiduan Precision Machinery Co.,Ltd